Specification
Size: 156 x 93 x 15mm
Weight: 130g
Installation Instructions
1 Make sure if your car complies with OBD II (or EU OBD) interface standard;
2 Open up the engine hood and look for the OBDII sticker. If there is a sticker of “OBDII
CERTIFIED then you can use our HUD. You can also check if your car have a
diagnostic Interface(the vast majority of cars made in china after 2006 have the diagnostic
Interface).
3 If your car has a diagnostic Interface of 16PINthen plug the OBDII cable with the
diagnostic Interface of 16PIN.
4 Put the non-slip mat on the relatively flat position of the car console. Then you put HUD on
the non-slip mat and adjust HUD.
5 Reflective film can be attached to the front windshield above HUD so that you can read the
parameters form the reflective film.
Remarks: tips of sticking the reflective film
A. Firstly spray some water on the position of sticking the reflective film;
B. Remove the protective layer of the film, then attach to the corresponding position;
C. Adjust the location, then use a small scraper or a smooth object to scrape the surface of the
film;
D. After a few minutes, the moisture will evaporate, then gently wipe off the water droplets and
dust.
6 Power-on test
You switch on HUD and HUD shows the current car voltage. Then HUD searches the car
computer system. If HUD displays data, such as car speed, engine speed etc, it indicates that the
product has been installed successfully.
HUD setting method
The value HUD displays is the value of car inside computer system. Since the value that the
car dashboard displays is a little bit different from the value of car inside computer system , so you
can enter the setup mode to fine-tune the display value of HUD to achieve exactly the same
values that the dashboard displays.
1 Specific setup
Firstly, you need to connect HUD to the car, then press the OK button for 3 seconds to enter
the setting mode. You can press the OK button once, the value of Menu 3 increases by 1. The
value of Menu 1 increases or decreases by 1 by dialing up or down the dial switch once, which
achieves the same values of HUD as the value the car dashboard displays
![Phone Holder Car [Upgrade Clip Never Fall] Car Phone Holder Mount Automobile Air Vent Hands Free Cell Phone Holder for Car Fit for All Car Mount for iPhone Android Smartphone from amazon offers](https://katkalashankar.wpenginepowered.com/wp-content/uploads/2022/09/81iReadMegL._AC_SX679_-336x220.jpg)
